Hearing Aid (DP-6K5A)
SET UP
1. There are 2 pre-set Modes on Mimitakara DP-6K5A (Stand- ard Mode & Noise Cancelling Mode)
- Standard Mode: Mostly used indoors where the enviroment is not too noisy.
- Noise Cancelling Mode: Used in louder environment such as outdoor public areas and restaurants.
2. To switch between the 2 modes click the M button (located in the center of the Mimitakara DP-6K5A device). A beep will be heard when switching between the 2 modes.
PAIRRING BLUETOOTH
1. Have both devices within arm's length of each other.
2. Turn on Mimitakara DP-6K5A and hold down M until the LED flashes BLUE and RED
3. Turn ON the Bluetooth function on your mobile device
4. Scan for nearby devices.
5. Pair with Mimitakara DP-6KA
6. Once successfully paired your phone will show that the status is "Connected" with "Mimitakara DP-6KA" and the device will start to flash BLUE
- Pair devices will remember each other unless pairing information is deleted, so there is no need to pair again. When the Bluetooth device that is connected to Mimitakara DP-6K5A is not palying any of media, the device will automatically swich bacj to being its primary function until the connected device starts playing media or receives a phone call again. Should the Bluetooth be disconnected due to range or any other reason, reconnect Mimitakara DP-6K5A with the device that you wish to pair it with.
SAFETY AND MAINTENACE
EAR BUD MAINTENANCE
Before each use : Clean your ear thoroughly
After each use: Remove all remaining debirs from the ear bud after each use. Ensure that the hole on the side of the bud is also free from any debris.
Use the cleaning brush to clean any earwax adhered on the ear bud, especially in and around the ear bud.
BATTERY MAINTENANCE
We suggust recharging Mimitakara DP-6K5A regardless of its battery status before sleeping at night.
Do not attempt to remove the battery as this may cause damages to Mimitakara DP-6K5A device or injuries.
Ensure the device is fully charged before removing it from charging.
WARING AND REMINDER
Do not listen for excessive time priods. Do not attemot to fix the unit yourself. Avoid liquids near the device. Avoid overcharging the battery. Keep away from direct sunlight Keep the device out of reach of children Do not attempt to open, fix, replace or remove any of the components. Avoid excessive volume levels and prolonged preiods of use. Avoid using the device while you are sleeping
1. Charging the battery before use is recommended but not required.
Mimitakara DP-6K5A comes pre-charged however initial charge will vary.
2. Ensure the Master Power Switch is switched ON in the direction of the arrow.
3. Wheb plugged into a power source:
- Solid RED LED Indicator: Charging
Soid BLUE LED Indicator: Fully Charged
4. 3+ hrs for full charge gives up to 10 hours of use
SWITING BETWEEN MODES
1. Secure fit the RED earphone into the RIGHT ear and the BLUE earphone into the LEFT ear.
2. Turn the unit ON by sliding the Master Power Switch in the direction of the display arrow. Then switch the Secondary Power Switch ON. The LED indicator light will flah PURPLE in long intervals.
3. The Mimitakara DP-6K5A has individual ear adjustable volume settings, adjust the volume for each ear indepen dently to suit your preferred specification. When the unit is turned off at the Secondary Power Switch it will resume from its previous setting after it is turned back on. Should you want to reset the unit back to its factory settings, simply turn the unit off from the Master Power Switch and back on agian to reset.
*CAUTION: LISTENING AT HIGH VOLUMES MAY DAMAGE YOUR HEARING*
4. We suggest clipping the device to the outside shirt pocket or collar to avoid it from rubbing against objects to reduce the static sounds. Ensure the microphone is not obstructed for optimum sound quality.
RECHARGING INSTRUCTIONS